| Property |
ASTM |
Result |
Color: |
|
White, dries clear. |
Viscosity: |
D 562 |
95 - 105 KU @ 25°C / 77°F |
Density: |
D 1475 |
8.55 lb/gal |
PH: |
|
> 8.0 ± .5 |
Percent Solids by Volume: |
D 2697 |
32% ± 2% |
Percent Solids by Weight: |
D 1644 |
32% ± 2% |
Flash Point: |
|
Same as water. |
% Elongation at Break: |
D 2370 |
312% |
Tensile Strength at Max Stress: |
D 2370 |
252 lb/in2 |
Flexibility: |
D 522 |
Pass (-5°C)* |
Fungi Resistance: |
G 21 |
Zero growth |
Coverage: |
250 sq.ft. per gallon, depending on porosity of surface. |
Recommended Coverage: |
The number of coats depends on surface porosity;
however, one coat is recommended. |
Min. Surface Application Temp.: |
7.2°C / 45°F. Do not allow to freeze. |
Drying Time: |
Will depend on climate conditions. Allow at least 2
hours drying time between coats. First coat must be
thoroughly dry before applying second coat. |
Packaging: |
5 gallon buckets. |
| * After 1000 hours accelerated weathering. |
| |
|
 |
|
When installed properly, this product can help reduce energy costs. Actual savings may vary based on geographic location and
individual building characteristics. The ENERGY STAR logo is a trademark of the US Environmental Protection Agency. As a
Charter Member, Advanced Coating Systems has determined that this product meets the ENERGY STAR guidelines for energy
efficiency.
This coating conforms to all Air Quality Management Districts and Air Pollution Control Districts requirements for Volatile Organic
Content in California, U.S.A. |
|
|
 CAUTION: Do not apply within two hours of sunset, rain, fog or freezing temperatures. All coatings must
be completely dry before exposing to water. Keep all containers covered when not in use. Dispose of all
containers in accordance with state and local environmental regulations. Keep away from children. If
ingested, DO NOT induce vomiting. Call Physician immediately.
Our technical data and suggestions are based on information from laboratory and field testing which we believe to be reliable and
correct. However, the accuracy and completeness of said tests are not guaranteed and not to be construed as a warranty, either
expressed or implied. Since the use of the material is beyond manufacturer’s control, buyer assumes all risk whatsoever as to their use
or results obtained. We guarantee out products conform to Advanced Coating Systems, Inc. quality control. Advanced Coating
Systems, Inc. warrants only the standard quality of material. Advanced Coating Systems, Inc. sole responsibility shall be to replace
that portion of our product, which proved to be defective. Installer is responsible to test adhesion and product compatibility with
substrate of all Energy Seal Coatings products prior to application. |
