Everlast Exterior Coatings Please contact our Main company for product options Wallsheild Wallbond WallGuard
 

WallShield - Technical Data

Elastomeric Wall Coating
Property ASTM Result
Color:
White; custom colors available.
Viscosity:
D 562
115 – 120 KU @ 25°C / 77°F
Density:
D 1475
11.75 ± .1 lb/gal
PH:
> 8.0 ± .5
Percent Solids by Volume:
D 2697
48% ± 2 %
Percent Solids by Weight:
D 1644
63% ± 2%
Flash Point:
Same as water.
Tensile Strength at Max Stress:
D 2370
100 lb/in2 @ 25°C / 77°F
% Elongation at Break:
D 2370
400% @ 25°C / 77°F
Flexibility:
D 522
Pass (-5°C)*
Permeability
D 1653
5
Fungi Resistance:
G 21
Zero Growth
Coverage:
1 gallon per 100 sq.ft. yields 10 dry mils.
Recommended Coverage:
Two coats.
Min. Surface Application Temp.:
7.2°C / 45°F. Do not allow to freeze.
Drying Time:
3 hours @ 25°C / 77°F, 50% relative humidity.
Packaging:
5 gallon buckets.
 
* After 1000 hours accelerated weathering.
This coating conforms to all Air Quality Management Districts and Air Pollution Control Districts requirements for Volatile Organic Content in California, U.S.A.

CAUTION: Do not apply within two hours of sunset, rain, fog or freezing temperatures. All coatings must be completely dry before exposing to water. Keep all containers covered when not in use. Dispose of all containers in accordance with state and local environmental regulations. Keep away from children. If ingested, DO NOT induce vomiting. Call Physician immediately.

Our technical data and suggestions are based on information from laboratory and field testing which we believe to be reliable and correct. However, the accuracy and completeness of said tests are not guaranteed and not to be construed as a warranty, either expressed or implied. Since the use of the material is beyond manufacturer’s control, buyer assumes all risk whatsoever as to their use or results obtained. We guarantee out products conform to Advanced Coating Systems, Inc. quality control. Advanced Coating Systems, Inc. warrants only the standard quality of material. Advanced Coating Systems, Inc. sole responsibility shall be to replace that portion of our product, which proved to be defective. Installer is responsible to test adhesion and product compatibility with substrate of all Energy Seal Coatings products prior to application.

 
Copyright © 2005 Advanced Coating Systems, Inc. All Rights Reserved